Configdefault - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

2

configDefault

configDefault
Restores system configuration parameters to default values.
Synopsis configdefault
Description Use this command to reset a subset of configuration settings to their factory defaults. All
configuration parameters are reset to their default values with the exception of the following:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Refer to the configure command for more information on default values for configuration
parameters.
Notes This command cannot be executed on an enabled switch. You must first disable the switch using
switchDisable.
Some configuration parameters are cached by the system. To avoid unexpected system behavior,
reboot the system after executing configDefault.
Note that configDefault does not completely remove all FCIP tunnels and GigE IP addresses
information. This may be an issue when attempting to use the same information to create new
tunnels or modify the existing ones.
When issuing configDefault on the Brocade 7500, it persistently disables the ports.
The execution of this command is subject to Admin Domain restrictions that may be in place. Refer
to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A, "Command Availability"
for details.
Operands none
Examples To restore the system configuration to default values:
78
Ethernet MAC address, IP address, subnetmask, and boot ROM parameters
IP gateway address
License keys
OEM customization
Product ID and Vendor ID
SNMP configuration
iSCSI configuration
System name
Chassis name
World Wide Name
Zoning configuration (includes aliases, zones, and configurations)
Security parameters and policies
User account passwords (includes all user config and all built-in accounts)
Switch PID format
Ethernet Link Mode
switch:admin> configdefault
Committing Configuration ...done.
Fabric OS Command Reference
53-1000599-02