Diagretry - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

diagRetry

Sets or displays diagnostic retry mode.
Synopsis diagretry [mode | -show]
Description Use this command to enable retry mode if the mode value is nonzero and to disable the retry mode
if the mode value is 0. The mode is saved in flash memory (and stays in that mode) until the next
execution of diagRetry. The mode becomes active as soon as this command is executed; it does not
require a reboot to take effect.
Retry mode modifies the behavior of the diagnostic test methods, power-on self-test (POST), and
burn-in scripts. The exact behavior depends on the tests and scripts that are run.
Note The execution of this command is subject to Admin Domain restrictions that may be in place. Refer
to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A, "Command Availability"
for details.
Operands This command has the following optional operands:
mode
-show
If no operand is specified, the current value is displayed.
Examples To view the current retry mode value:
See Also none
Fabric OS Command Reference
53-1000599-02
Specify 1 to enable, 0 to disable retry mode.
Specify this operand to display the current mode setting.
switch:admin> diagretry -show
Diagnostic Retry Mode is currently enabled.
2
diagRetry
107