Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual page 257

In Access Gateway mode, only the following classes are supported. F/FL_Port (Copper) class is
supported only on Embedded platforms.
.
TABLE 13
Class
Environmental
SFP
Port
Fabric
FFL_Port (Optical
FFL_Port (Copper)
Resource class
EE Performance Monitor
Filter Performance Monitor
Resource
Notes This command requires a Fabric Watch license.
The execution of this command is subject to Admin Domain restrictions that may be in place. Refer
to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A, "Command Availability"
for details.
Not all platforms support fans or power supplies. If you attempt to configure values for these items
the following displays: "ERROR: No threshold available.
Operands This command has the following optional operands:
--enable --port portNumber
Fabric OS Command Reference
53-1000599-02
Access Gateway mode
Area
Temperature
Fan*
Power Supply*
Temperature
RXP
TXP
Current
Voltage
Link failure
Sync loss
Signal loss
Protocol error
Invalid words
Invalid CRCs
RX Performance
TX Performance
State Changes
E_Port downs
Fabric reconfigure
Domain ID changes
Segmentation changes
Zone changes
Fabric<->QL
Fabric logins
SFP state changes
Same as Port class
Same as Port class
Flash area
Invalid CRCS
RX Performance
TX Performance
Customer Defined
Flash
Enables all thresholds associated with a certain port.
2
fwConfigure
231