Navigation Of The Cli Command Tree - HP 316095-B21 - StorageWorks Edge Switch 2/24 Reference Manual

Table 1–2: CLI Command Tree (Continued)
Commands are shown, with the exception of the zoning commands, in alphabetical
order to make them easier to locate. Although the commands can be entered in any
order, depending on the results desired, the order shown in
the zoning commands is a typical order in which the zoning commands are entered.
Note that the order in which commands are entered determines the order in which the
show commands display the values. Refer to
of show commands output.

Navigation of the CLI Command Tree

Once the administrator or operator logs in and receives the Root> prompt, the CLI
commands are accessed by navigating up and down the CLI command tree.
To move from the root through the any of the four extended branches, enter the name
of the next branch as shown in
config.port.name command to configure the name for port 4 on the Switch, this
series of commands is entered:
Root> config
Config> port
Config.Port> name 4 "HP Tape Drive"
CLI reference guide for directors and edge switches
ip -----------------
loginServer
nameServer
port ---------------
security -----------
switch
system
zoning
Table 1–2 on page
ethernet
config
info
nodes
status
technology
fabricBinding
portBinding
switchBinding
Table 1–2 on page 1-4
Chapter 2, CLI Commands
1-4. For example, to use the
Introduction
for
for examples
1–7