CLI Commands
config.port.name
Syntax
name portNumber "portName"
Purpose
This command sets the name for a port.
Parameters
This command has two required parameters:
portNumber
portName
Command Example
Root> config port name 4 "HP Tape Drive"
2–16
Specifies the port number. Valid values are:
0–15 for the Edge Switch 2/16
0–23 for the Edge Switch 2/24
0–31 for the Edge Switch 2/32
0–63 for the Director 2/64
0–127 and 132–144 for the Director 2/140
Specifies the name for the port. The port name
must not exceed 24 characters in length.
CLI reference guide for directors and edge switches