HP 316095-B21 - StorageWorks Edge Switch 2/24 Reference Manual page 175

Message
Error 81: Default Zone
Enabled
Error 82: Invalid Interop
Mode
Error 83: Not Allowed in
Open Fabric Mode
Root> config switch
interopMode open
Error 88: Invalid
Feature Key Length
CLI reference guide for directors and edge switches
Description
The request cannot be
completed because the
default zone is enabled.
The value entered for the
interoperability mode is not
valid.
Zone member cannot be put
into the default zone while
the product is operating in
Open Fabric 1.0 mode. For
example, if the following
series of commands is
entered, Error 83 results:
Root> config zoning
setDefZoneState true
The value of the specified
feature key is longer than
the maximum length
allowed.
Error Messages
Action
Disable the default zone
before reentering the
command.
The interoperability
mode for the Director or
Edge Switch must be
Homogenous Fabric or
Open Fabric 1.0. Enter
either Homogenous
Fabric or Open
Fabric 1.0 to set the
interoperability mode.
Root> maint system
setOnlineState false
Configure the
interoperability mode as
Homogenous Fabric in
the previous series of
commands.
Refer to
config.features.installKe
y on page 2-5
for
requirements, and
reenter the feature key. If
problems persist, contact
your sales
representative.
A–11