Config.snmp.addcommunity - HP 316095-B21 - StorageWorks Edge Switch 2/24 Reference Manual

config.snmp.addCommunity

Syntax
addCommunity commIndex "commName" writeAuthorization trapRecipient
udpPortNum
Purpose
This command adds an SNMP community to the SNMP configuration.
Parameters
This command has five parameters. Up to six community names and trap recipients
may be defined.
commIndex
commName
writeAuthorization Specifies the write authorization state of the
trapRecipient
udpPortNum
CLI reference guide for directors and edge switches
Specifies the community to be created or edited.
Valid values are integers in the range 1–6.
Specifies the community name of the community
specified by commIndex.
The community name must not exceed 32 characters
in length. Valid characters include all those in the ISO
Latin-1 character set. Duplicate community names are
allowed, but the corresponding
writeAuthorization values must match.
community.
Valid values are enabled and disabled. Boolean
1 and 0 may be substituted as values.
Specifies the trap recipient. Values must be 4 bytes in
dotted-decimal format.
Specifies the user datagram protocol (UDP) port
number to which the Director sends traps for each
recipient.
The value can be a decimal number or the default,
which 162. Valid values include all legal UDP port
numbers.
CLI Commands
2–39