Default Configuration
The default value is 2 seconds
Command Modes
Global configuration
Usage Guidelines
•
It is recommended that the TxDelay would be less than 0.25 of the LLDP timer interval.
Examples
The following example specifies the delay between successive LLDP frame transmissions initiated
by value/status changes in the LLDP local systems MIB.
Console (config) # lldp tx-delay 7
lldp optional-tlv
To specify which optional TLVs from the basic set should be transmitted, use the lldp optional-tlv
command in interface configuration mode. To revert to the default setting, use the no form of this
command.
Syntax
lldp optional-tlv tlv1 [tlv2 ... tlv5]
no lldp optional-tlv
•
tlv — Specifies TLV that should be included. Available optional TLVs are: port-desc, sys-
name, sys-desc and sys-cap . (Range 1-8192 seconds).
Default Configuration
No optional TLV is transmitted.
Command Modes
Interface configuration (Ethernet)
User Guidelines
•
There are no user guidelines for this command.
Example
The following example specifies which optional TLV (2)s from the basic set should be transmitted.
Console(config)# interface ethernet g5
Console(config-if)# lldp optional-tlv sys-name
163
LLDP Commands