Setverbose - Brocade Communications Systems 8 Command Reference Manual

setVerbose

Specifies module verbose level.
Synopsis setverbose [module_name][level]
Description Use this command to set the verbose level of the specified module. These levels filter the display of
the debug message to the serial console. By default, no debug messages are displayed.
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands This command has the following operands:
module_name
level
Examples To set the verbose level of a module named NS to value 3:
See Also dbgShow, setDbg
Fabric OS Command Reference
53-1001764-02
Specify the name of the module for which the verbose level is to be set;
module names are case-sensitive.
Specify the verbose level (0 to 9).
switch:admin> setverbose NS 3
switch:admin> dbgshow NS
Module NS, debug level = 0, verbose level = 3
2
setVerbose
867