Overview Of Configuring And Installing Cisco Unified Ip Phones; Configuring Cisco Unified Ip Phones In Cisco Unified Callmanager - Cisco 7906G Administration Manual

Chapter 1 An Overview of the Cisco Unified IP Phone
Overview of Configuring and Installing
Cisco Unified IP Phones
Configuring Cisco Unified IP Phones in Cisco Unified
CallManager
Cisco Unified IP Phone 7906G and 7911G Administration Guide for Cisco Unified CallManager
OL-10008-01
A user can barge into an authenticated call, even if the phone that is used to barge
is nonsecure. The authentication icon continues to appear on the authenticated
devices in the call, even if the initiator phone does not support security.
When deploying a new unified communications system, system administrators
and network administrators must complete several initial configuration tasks to
prepare the network for unified communications service. For information and a
checklist for setting up and configuring a complete Cisco Unified
Communications network, refer to the "System Configuration Overview" chapter
in the Cisco Unified CallManager System Guide.
After you have set up the unified communications system and configured
system-wide features in Cisco Unified CallManager, you can add IP phones to the
system.
The following topics provide an overview of procedures for adding
Cisco Unified IP Phones to your network:

Configuring Cisco Unified IP Phones in Cisco Unified CallManager,

•
page 1-17
Installing Cisco Unified IP Phones, page 1-22
•
To add phones to the Cisco Unified CallManager database, you can use:
Auto-registration
•
Cisco Unified CallManager Administration
•
Bulk Administration Tool (BAT)
•
BAT and the Tool for Auto-Registered Phones Support (TAPS)
•
For more information about these choices, see the
Cisco Unified CallManager Database" section on page

Overview of Configuring and Installing Cisco Unified IP Phones

"Adding Phones to the
2-11.
1-17