3
Configuring the Switch
CLI – Use the reload command to restart the switch. When prompted, confirm that
you want to reset the switch.
Console#reload
System will be restarted, continue <y/n>? y
When restarting the system, it will always run the Power-On Self-Test.
Console(config)#logging sendmail host 192.168.1.19
Console(config)#logging sendmail level 3
Console(config)#logging sendmail source-email
bill@this-company.com
Console(config)#logging sendmail destination-email
ted@this-company.com
Console(config)#logging sendmail
Console#
Resetting the System
Web – Click System, Reset. Click the Reset button to reboot the switch. When
prompted, confirm that you want reset the switch.
CLI – Use the reload command to restart the switch. When prompted, confirm that
you want to reset the switch.
Console#reload
System will be restarted, continue <y/n>? y
Note:
When restarting the system, it will always run the Power-On Self-Test. It will also
retain all configuration information stored in non-volatile memory (see "Saving or
Restoring Configuration Settings" on page 3-22).
3-34
Figure 3-21 Resetting the System
4-22
4-13
Need help?
Do you have a question about the 8126PL2-F - annexe 1 and is the answer not in the manual?