Show Dot1X - SMC Networks 8126PL2-F - annexe 1 Management Manual

4
Command Line Interface
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout supp-timeout 300
Console(config-if)#

show dot1x

This command shows general port authentication related settings on the switch or a
specific interface.
Syntax
show dot1x [statistics] [interface interface]
• statistics - Displays dot1x status for each port.
• interface
• ethernet unit/port
- unit - Stack unit. (Range: 1)
- port - Port number. (Range: 1-26/50)
Command Mode
Privileged Exec
Command Usage
This command displays the following information:
• Global 802.1X Parameters – Shows whether or not 802.1X port
authentication is globally enabled on the switch.
• 802.1X Port Summary – Displays the port access control parameters for
each interface, including the following items:
- Status
- Operation Mode
- Mode
- Authorized
• 802.1X Port Details – Displays the port access control parameters for each
interface, including the following items:
- reauth-enabled
- reauth-period
- quiet-period
- tx-period
- supplicant-timeout
- server-timeout
- reauth-max
4-118
– Administrative state for port access control.
– Dot1x port control operation mode (page 4-114).
– Dot1x port control mode (page 4-113).
– Authorization status (yes or n/a - not authorized).
– Periodic re-authentication (page 4-115).
– Time after which a connected client must be
re-authenticated (page 4-116).
– Time a port waits after Max Request Count is
exceeded before attempting to acquire a new
client (page 4-116).
– Time a port waits during authentication session
before re-transmitting EAP packet (page 4-117).
– Supplicant timeout.
– Server timeout.
– Maximum number of reauthentication attempts.