Cluster Ip-Pool; Cluster Member - SMC Networks 8126PL2-F - annexe 1 Management Manual

4
Command Line Interface

cluster ip-pool

This command sets the cluster IP address pool. Use the no form to reset to the
default address.
Syntax
cluster ip-pool ip-address
no cluster ip-pool
ip-address - The base IP address for IP addresses assigned to cluster
Members. The IP address must start 10.x.x.x.
Default Setting
10.254.254.1
Command Mode
Global Configuration
Command Usage
• An "internal" IP address pool is used to assign IP addresses to Member
switches in the cluster. Internal cluster IP addresses are in the form
10.x.x.member-ID. Only the base IP address of the pool needs to be set since
Member IDs can only be between 1 and 16.
Set a Cluster IP Pool that does not conflict with addresses in the network IP
•
subnet. Cluster IP addresses are assigned to switches when they become
Members and are used for communication between Member switches and the
Commander
• You cannot change the cluster IP pool when the switch is currently in Commander
mode. Commander mode must first be disabled.
Example
Console(config)#cluster ip-pool 10.2.3.4
Console(config)#

cluster member

This command configures a Candidate switch as a cluster Member. Use the no form
to remove a Member switch from the cluster.
Syntax
cluster member mac-address mac-address id member-id
no cluster member id member-id
• mac-address - The MAC address of the Candidate switch.
• member-id - The ID number to assign to the Member switch. (Range: 1-16)
Default Setting
No Members
Command Mode
Global Configuration
4-58
.