Show Spanning-Tree Mst Configuration; Vlan Commands - SMC Networks 8126PL2-F - annexe 1 Management Manual

show spanning-tree mst configuration

This command shows the configuration of the multiple spanning tree.
Command Mode
Privileged Exec
Example
Console#show spanning-tree mst configuration
Mstp Configuration Information
--------------------------------------------------------------
Configuration name: R&D
Revision level:0
Instance Vlans
--------------------------------------------------------------
1 2
Console#

VLAN Commands

A VLAN is a group of ports that can be located anywhere in the network, but
communicate as though they belong to the same physical segment. This section
describes commands used to create VLAN groups, add port members, specify how
VLAN tagging is used, and enable automatic VLAN registration for the selected
interface.
Command Groups
GVRP and Bridge Extension Configures GVRP settings that permit automatic VLAN learning;
Editing VLAN Groups
Configuring VLAN
Interfaces
Displaying VLAN
Information
Configuring 802.1Q
Tunneling
Configuring Private VLANs
Configuring Protocol VLANs Configures protocol-based VLANs based on frame type and protocol
Table 4-66
Function
shows the configuration for bridge extension MIB
Sets up VLAN groups, including name, VID and state
Configures VLAN interface parameters, including ingress and egress
tagging mode, ingress filtering, PVID, and GVRP
Displays VLAN groups, status, port members, and MAC addresses
Configures 802.1Q Tunneling (QinQ Tunneling)
Configures private VLANs, including uplink and downlink ports
VLAN Commands
VLANs
4
Page
4-216
4-220
4-222
4-228
4-229
4-233
4-240
4-215