Show Gvrp Configuration; Garp Timer - SMC Networks 8126PL2-F - annexe 1 Management Manual

4
Command Line Interface

show gvrp configuration

This command shows if GVRP is enabled.
Syntax
show gvrp configuration [interface]
interface
• ethernet unit/port
- unit - Stack unit. (Range: 1)
- port - Port number. (Range: 1-26/50)
• port-channel channel-id (Range: 1-32)
Default Setting
Shows both global and interface-specific configuration.
Command Mode
Normal Exec, Privileged Exec
Example
Console#show gvrp configuration ethernet 1/6
Eth 1/ 6:
GVRP configuration: Enabled
Console#

garp timer

This command sets the values for the join, leave and leaveall timers. Use the no
form to restore the timers' default values.
Syntax
garp timer {join | leave | leaveall} timer-value
no garp timer {join | leave | leaveall}
• {join | leave | leaveall} - Which timer to set.
• timer-value - Value of timer.
Ranges:
join: 20-1000 centiseconds
leave: 60-3000 centiseconds
leaveall: 500-18000 centiseconds
Default Setting
• join: 20 centiseconds
• leave: 60 centiseconds
• leaveall: 1000 centiseconds
Command Mode
Interface Configuration (Ethernet, Port Channel)
4-218