Show Ip Access-Group; Table 4-46 Mac Acl Commands; Mac Acls - SMC Networks 8126PL2-F - annexe 1 Management Manual

10/100/1000 l2-lite smb poe gigabit switch
Hide thumbs Also See for 8126PL2-F - annexe 1:
Table of Contents

Advertisement

Example
Console(config)#int eth 1/25
Console(config-if)#ip access-group david in
Console(config-if)#
Related Commands
show ip access-list (4-148)

show ip access-group

This command shows the ports assigned to IP ACLs.
Command Mode
Privileged Exec
Example
Console#show ip access-group
Interface ethernet 1/25
IP access-list david in
Console#
Related Commands
ip access-group (4-148)

MAC ACLs

The commands in this section configure ACLs based on hardware addresses,
packet format, and Ethernet type. To configure MAC ACLs, first create an access list
containing the required permit or deny rules, and then bind the access list to one or
more ports
Command
access-list mac
permit, deny
show mac access-list
mac access-group
show mac access-group

Table 4-46 MAC ACL Commands

Function
Creates a MAC ACL and enters configuration mode
Filters packets matching a specified source and
destination address, packet format, and Ethernet type
Displays the rules for configured MAC ACLs
Adds a port to a MAC ACL
Shows port assignments for MAC ACLs
Access Control List Commands
Mode
GC
MAC-ACL
PE
IC
PE
4
Page
4-150
4-150
4-152
4-152
4-153
4-149

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 8126PL2-F - annexe 1 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Tigerswitch smc8126pl2-f

Table of Contents