Priority Watch Operation - Icom IC-T70A Instruction Manual

8
PRIORITY WATCH

■ Priority watch operation

D Memory/call channel and memory scan watch
q Select the VFO mode, then set an operating frequency.
w Select the channel(s) to be watched.
For memory channel watch:
Select a desired memory channel.
For call channel watch:
Select a desired call channel.
For memory scan watch:
➥ Select the memory mode, or a desired bank group.
➥ Push and hold [SCAN](H/M/L) for 1 sec. to enter the
scan type selection mode.
➥ Rotate [DIAL] to select a desired scan type, then push
[SCAN](H/M/L) again to start the memory/bank scan.
e Push [SET] to enter the Set mode.
r Rotate [DIAL] to select the priority watch set item, then
rotate [VOL] to select "On."
• Select "bELL" if the priority beep function is desired.
t Push [V/M/C] to exit the Set mode and start the watch.
• The "PRIO" icon appears.
• The transceiver checks the memory/bank channel(s) or call
channel every 5 seconds.
• The watch resumes according to the selected scan resume set-
ting. (p. 47)
y Push [V/M/C] to cancel the watch.
49
• During priority watch
Monitors VFO frequency
for 5 seconds.
• During priority watch with priority beep
A beep tone sounds and "S" icon blinks when a signal is
received on a memory or call channel.
Pauses on a memory
or call channel when
a signal is received.