Basic Operation; Setting A Frequency; Via The Keypad; Other Methods - Icom IC-T22A Instruction Manual

ms 3
BASIC OPERATION
Hi Mode selection
VFO mode is used for setting a desired frequency within the
band range.
'» Push [VFO] to select VFO mode.
Memory (call) mode is used for operation of memory (call)
channels which have programmed frequencies.
'Push [MR] to select memory
mode.
* To program a memory, refer to p. 17.
'» Push [CALL] to select a call chan-
nel.
Log memory/repeater memory mode is used to recall your
last-transmitted frequency or the frequency and duplex set-
tings for the last repeater used.
'* Push [LOGeM] once to select the
log memory and again to select the
repeater memory.
* Subsequent pushes toggle between
@ Setting a frequency
© Via the keypad
@ Push [VFO] to select VFO Gro)
mode.
@ Push 4 digit keys, starting
from the 1 MHz digit, to
input a frequency.
*When a digit is mistakenly
input, push [(vFo)CLR] and
input from the beginning.
*"0, "2, "5" and "7" are accept-
able for the 1 kHz digits (de-
pending on the 10 kHz digit).
© Other methods
> VIA THE DIAL: Rotate [DIAL] to change the frequency ac-
cording to the set tuning steps.
» VIA [FUNC] + THE DIAL: While pushing [FUNC] rotate
[DIAL] to change the frequency according to the set dial
select step.
» VIA THE [AJ{V] KEYS: Push [AJ[V] to increment/decre-
ment the frequency according to the set tuning steps.
Y NOTE: Pushing [A)V] for more than 1 sec. activates a
G scan — push [A] or [VY] again momentarily to stop it.