Configuring An Snmp Community - 3Com Baseline 2928 PWR Plus User Manual

Table 1-4 Configuration items for creating an SNMP view
Item
View Name
Rule
MIB Subtree OID
Subtree Mask
Adding rules to an SNMP view
Click the icon corresponding to the specified view on the page as shown in
for the view ViewDefault window appears as shown in
click Apply to add the rule for the view.
SNMP view.
Figure 1-8 Add rules to an SNMP view
You can also click the
and then you can enter the page to modify the view.
Return to SNMPv1 or SNMPv2c configuration task list

Configuring an SNMP Community

Select Device > SNMP from the navigation tree, then click the Community tab to enter the page as
shown in Figure
Set the SNMP view name.
Select to exclude or include the objects in the view range determined by
the MIB subtree OID and subtree mask.
Set the MIB subtree OID (such as 1.4.5.3.1) or name (such as system).
MIB subtree OID identifies the position of a node in the MIB tree, and it can
uniquely identify a MIB subtree.
Set the subtree mask.
If no subtree mask is specified, the default subtree mask (all Fs) will be
used for mask-OID matching.
icon corresponding to the specified view on the page as shown in
1-9. Click Add to enter the Add SNMP Community page as shown in
Description
Figure 1-8. After configuring the parameters,
Table 1-4 describes the configuration items for creating an
or SNMPv3 configuration task
1-7
Figure 1-5, the Add rule
Figure 1-5,
list.
Figure 1-10.