Configuring An Snmp Group - 3Com Baseline 2928 PWR Plus User Manual

Figure 1-9 Configure an SNMP community
Figure 1-10 Create an SNMP Community
Table 1-5 describes the configuration items for configuring an SNMP community.
Table 1-5 Configuration items for configuring an SNMP community
Item
Community Name
Access Right
View
ACL
Return to SNMPv1 or SNMPv2c configuration task

Configuring an SNMP Group

Select Device > SNMP from the navigation tree, then click the Group tab to enter the page as shown in
Figure 1-11. Click Add to enter the Add SNMP Group page as shown in
Set the SNMP community name.
Configure SNMP NMS access right
Read only: The NMS can perform read-only operations to the MIB objects
when it uses this community name to access the agent,
Read and write: The NMS can perform both read and write operations to
the MIB objects when it uses this community name to access the agent.
Specify the view associated with the community to limit the MIB objects that
can be accessed by the NMS.
Associate the community with a basic ACL to allow or prohibit the access to
the agent from the NMS with the specified source IP address.
1-8
Description
list.
Figure 1-12.