3Com Baseline 2928 PWR Plus User Manual page 305

Figure 1-6 Configure a default route
Type 0.0.0.0 for Destination IP Address.
Select 0 (0.0.0.0) from the Mask drop-down list.
Type 1.1.5.5 for Next Hop.
Click Apply.
Verify the configuration
# Display the route table.
Enter the IPv4 route page of Switch A, Switch B, and Switch C respectively to verify that the newly
configured static routes are displayed as active routes on the page.
# Use the ping command for verification.
Ping Host B from Host A (assuming both hosts run Windows XP).
C:\Documents and Settings\Administrator>ping 1.1.3.2
Pinging 1.1.3.2 with 32 bytes of data:
Reply from 1.1.3.2: bytes=32 time=1ms TTL=128
Reply from 1.1.3.2: bytes=32 time=1ms TTL=128
Reply from 1.1.3.2: bytes=32 time=1ms TTL=128
Reply from 1.1.3.2: bytes=32 time=1ms TTL=128
Ping statistics for 1.1.3.2:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
1-7