3Com Baseline 2928 PWR Plus User Manual page 406

Figure 1-6 RADIUS parameter configuration
Table 1-5 lists the RADIUS parameters.
Table 1-5 RADIUS parameters
Item
Server Type
Authentication
Server Shared Key
Confirm
Authentication
Shared Key
Accounting Server
Shared Key
Confirm Accounting
Shared Key
NAS-IP
Timeout Interval
Specify the type of the RADIUS server supported by the device, including:
extended: Specifies an extended RADIUS server (usually an iMC
server). That is, the RADIUS client (the device) and RADIUS server
communicate using the proprietary RADIUS protocol and packet format.
standard: Specifies a standard RADIUS server. That is, the RADIUS
client (the device) and RADIUS server communicate using the standard
RADIUS protocol and packet format defined in RFC 2138/2139 or later.
Specify and confirm the shared key for the authentication server. These two
parameters must have the same values.
Specify and confirm the shared key for the accounting server. These two
parameters must have the same values.
Specify the source IP address for the device to use in RADIUS packets to be
sent to the RADIUS server. It is recommended to use a loopback interface
address instead of a physical interface address as the source IP address,
because if the physical interface is down, the response packets from the
server cannot reach the device.
Set the RADIUS server response timeout.
1-9
Description