Configuration procedure
1)
Configure Switch A
# Enable LLDP on GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2. (Optional. By default, LLDP is
enabled on Ethernet ports.)
# Set the LLDP operating mode to Rx on GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2.
Select Network > LLDP from the navigation tree to enter the Port Setup tab, as shown in
1-15. Select port GigabitEthernet1/0/1 and GigabitEthernet1/0/2 and click Modify Selected. The
page shown in
Figure 1-16
Figure 1-15 The Port Setup tab
appears.
1-21
Figure