Figure 1-10 Configure a stack port on Switch C
In the Port Settings area, select the check box before GigabitEthernet1/0/1.
Click Enable.
Now, Switch C becomes a slave device.
# On Switch D, configure local port GigabitEthernet 1/0/1 connecting with Switch B as a stack port.
Select IRF from the navigation tree of Switch D to enter the page of the Setup tab, and then
perform the following configurations, as shown in
In the Port Settings area, select the check box before GigabitEthernet1/0/1.
Click Enable.
Figure
1-10.
1-10