Creating An Ipv4 Static Route - 3Com Baseline 2928 PWR Plus User Manual

Field
Preference
Next Hop
Interface

Creating an IPv4 Static Route

Select Network > IPv4 Routing from the navigation tree and click the Create tab to enter the IPv4
static route configuration page, as shown in
Figure 1-2 Create an IPv4 static route
Table 1-2 describes the IPv4 static route configuration items:
Table 1-2 IPv4 static route configuration items
Item
Destination IP Address
Mask
Preference value for the IPv4 route
The smaller the number, the higher the preference.
Nexthop IP address of the IPv4 route
Outgoing interface of the IPv4 route. Packets destined for the
specified network segment will be sent out the interface.
Figure 1-2.
Type the destination host or network IP address, in dotted decimal
notation.
Type the mask of the destination IP address.
Select a mask length (number of consecutive 1s in the mask) or a
mask in dotted decimal notation from the drop-down list.
1-3
Description
Description