Configuring An Snmp Test - 3Com 4500G Family Configuration Manual

To do...
Configure the number of
packets sent in a UDP jitter
probe
Configure the interval for
sending packets in a UDP jitter
probe
Configure the time for waiting
for a response in a UDP jitter
test
Configure the source IP
address of a probe request in a
test operation
Configure common optional
parameters
The number of probes made in a UDP jitter test depends on the probe count command, while the
number of probe packets sent in each probe depends on the configuration of the probe
packet-number command.

Configuring an SNMP Test

An SNMP query test is used to test the time the NQA client takes to send an SNMP query packet to the
SNMP agent and then receive a response packet.
Configuration prerequisites
The SNMP agent function must be enabled on the device serving as an SNMP agent before an SNMP
test. For the configuration of SNMP agent, see SNMP Configuration in the System Volume.
Configuring an SNMP test
Follow these steps to configure an SNMP test:
To do...
Enter system view
Enter NQA test group view
Configure the test type as
SNMP and enter test type view
Use the command...
probe packet-number
packet-number
probe packet-interval
packet-interval
probe packet-timeout
packet-timeout
source ip ip-address
See Configuring Optional
Parameters Common to an
NQA Test Group
Use the command...
system-view
nqa entry admin-name
operation-tag
type snmp
1-12
Remarks
Optional
10 by default.
Optional
20 milliseconds by default.
Optional
3000 milliseconds by default.
Optional
By default, no source IP
address is specified.
The source IP address must be
that of an interface on the
device and the interface must
be up. Otherwise, the test will
fail.
Optional
Remarks
—
—
Required