Creating A Traffic Behavior - 3Com Baseline 2928 PWR Plus User Manual

Item
Service VLAN
VLAN
Customer
VLAN
ACL IPv4
Return to QoS policy configuration task

Creating a Traffic Behavior

Select QoS > Behavior from the navigation tree and click the Create tab to enter the page for creating
a traffic behavior, as shown in
Figure 2-13 The page for creating a traffic behavior
Table 2-13 describes the configuration items of creating a behavior.
Define a rule to match service VLAN IDs.
If multiple such rules are configured for a class, the new configuration
does not overwrite the previous one.
You can configure multiple VLAN IDs each time. If the same VLAN ID is
specified multiple times, the system considers them as one. The
relationship between different VLAN IDs is logical OR. After such a
configuration. You can specify VLAN IDs in two ways:
Enter a range of VLAN IDs, such as 10-500. The number of VLAN
IDs in the range is not limited.
Specify a combination of individual VLAN IDs and VLAN ID ranges,
such as 3, 5-7, 10. You can specify up to eight VLAN IDs in this way.
Define a rule to match customer VLAN IDs.
If multiple such rules are configured for a class, the new configuration
does not overwrite the previous one.
You can configure multiple VLAN IDs each time. If the same VLAN ID is
specified multiple times, the system considers them as one. The
relationship between different VLAN IDs is logical OR. You can specify
VLAN IDs in two ways:
Enter a range of VLAN IDs, such as 10-500. The number of VLAN
IDs in the range is not limited.
Specify a combination of individual VLAN IDs and VLAN ID ranges,
such as 3, 5-7, 10. You can specify up to eight VLAN IDs in this way.
Define an IPv4 ACL-based rule.
The ACLs available for selection are existing IPv4 ACLs.
list.
Figure 2-13.
2-17
Description