3Com Baseline 2928 PWR Plus User Manual page 86

Item
MDI
Flow Control
Power Save
Max MAC Count
Set the Medium Dependent Interface (MDI) mode of the port. Two
types of Ethernet cables can be used to connect Ethernet devices:
crossover cable and straight-through cable. To accommodate these
two types of cables, an Ethernet port can operate in one of the
following three MDI modes: across, normal, and auto.
An Ethernet port is composed of eight pins. By default, each pin has its
particular role. For example, pin 1 and pin 2 are used for transmitting
signals; pin 3 and pin 6 are used for receiving signals. You can change
the pin roles by setting the MDI mode.
For an Ethernet port in across mode, pin 1 and pin 2 are used for
transmitting signals; pin 3 and pin 6 are used for receiving signals.
The pin roles are not changed.
For an Ethernet port in auto mode, the pin roles are decided through
auto negotiation.
For an Ethernet port in normal mode, the pin roles are changed. Pin
1 and pin 2 are used for receiving signals; pin 3 and pin 6 are used
for transmitting signals.
To enable normal communication, you must connect the local transmit
pins to the remote receive pins. Therefore, you should configure the
MDI mode depending on the cable types.
Normally, the auto mode is recommended. The other two modes
are used only when the device cannot determine the cable type.
When straight-through cables are used, the local MDI mode must
be different from the remote MDI mode.
When crossover cables are used, the local MDI mode must be the
same as the remote MDI mode, or the MDI mode of at least one end
must be set to auto.
SFP optical ports do not support this feature.
Enable or disable flow control on the port.
With flow control enabled at both sides, when traffic congestion occurs
on the ingress port, the ingress port will send a Pause frame notifying
the egress port to temporarily suspend the sending of packets. The
egress port is expected to stop sending any new packet when it
receives the Pause frame. In this way, flow control helps to avoid
dropping of packets.
Flow control works only after it is enabled on both the ingress and
egress ports.
Enable or disable auto power down on the port.
With auto power down enabled, when an Ethernet port does not
receive any packet for a certain period of time, it automatically enters
the power save mode and resumes its normal state upon the arrival of
a packet.
By default, auto power down is disabled.
Set the MAC learning limit on the port. Available options include:
User Defined: Select this option to set the limit manually.
No Limited: Select this option to set no limit.
1-3
Description