3Com Baseline 2928 PWR Plus User Manual page 153

Figure 1-15 Traps configuration
Figure 1-16 Add a target host of SNMP traps
Table 1-8 describes the configuration items for adding a target host of SNMP traps.
Table 1-8 Configuration items for adding a target host
Item
Set the destination IP address.
Destination IP
Select the IP address type: IPv4 or IPv6, and then type the corresponding IP
Address
address in the text box according to the IP address type.
Set the security name, which can be an SNMPv1 community name, an
Security Name
SNMPv2c community name, or an SNMPv3 user name.
UDP Port Set UDP port number.
Select the security model, that is, the SNMP version. Ensure that the SNMP
Security Model version is the same with that on the NMS; otherwise, the NMS cannot receive
any trap.
Set the authentication and privacy mode for SNMP traps when the security
model is selected as v3. The available security levels are: no authentication no
privacy, authentication but no privacy, and authentication and privacy.
Security Level
When the security model is selected as v1 or v2c, the security level is no
authentication no privacy, and cannot be modified.
Description
1-12