Configuring An Snmp View - 3Com Baseline 2928 PWR Plus User Manual

Figure 1-4 Set up
Table 1-3 describes the configuration items for enabling SNMP.
Table 1-3 Configuration items for enabling SNMP
Item
SNMP
Local Engine ID
Maximum Packet Size
Contact
Location
SNMP Version
Return to SNMPv1 or SNMPv2c configuration task list

Configuring an SNMP View

Select Device > SNMP from the navigation tree, and then click the View tab to enter the page as shown
in Figure 1-5.
Specify to enable or disable SNMP.
Configure the local engine ID.
The validity of a user after it is created depends on the engine ID of the
SNMP agent. If the engine ID when the user is created is not identical to
the current engine ID, the user is invalid.
Configure the maximum size of an SNMP packet that the agent can
receive/send.
Set a character string to describe the contact information for system
maintenance.
If the device is faulty, the maintainer can contact the manufacture
factory according to the contact information of the device.
Set a character string to describe the physical location of the device.
Set the SNMP version run by the system
1-5
Description
or SNMPv3 configuration task list.