Figure 1-6 The page for modifying LLDP settings on ports in batch
Table 1-8
describes the port LLDP configuration items.
Table 1-8 Port LLDP configuration items
Item
Interface Name
DLDP State
LLDP Operating
Basic Settings
Mode
Encapsulation
Format
Description
Displays the name of the port or ports you are configuring.
Displays the LLDP enabling status on the port you are
configuring.
This field is not available when you batch-configure ports.
Set the LLDP operating mode on the port or ports you are
configuring. Available options include:
TxRx: Sends and receives LLDPDUs.
Tx: Sends but not receives LLDPDUs.
Rx: Receives but not sends LLDPDUs.
Disable: Neither sends nor receives LLDPDUs.
Set the encapsulation for LLDPDUs. Available options
include:
ETHII: Encapsulates outgoing LLDPDUs in Ethernet II
frames and processes an incoming LLDPDU only if its
encapsulation is Ethernet II.
SNAP: Encapsulates outgoing LLDPDUs in Ethernet II
frames and processes an incoming LLDPDU only if its
encapsulation is Ethernet II.
LLDP-CDP PDUs use only SNAP encapsulation.
1-10