Inspecting Disc Blade Hardware - MacDon R1 Series Operator's Manual

Rotary disc pull-type
Hide thumbs Also See for R1 Series:
Table of Contents

Advertisement

IMPORTANT:
The disc blades have cutting edges on both sides so that
the blades can be turned over and reused. The twist in each
blade determines the cutting direction. If you are unsure
which direction the spindles rotate, refer to
Disc Cutterbar Crop Stream Configuration, page 180
instructions.

Inspecting Disc Blade Hardware

Inspect the blade attachment hardware each time the blades are changed.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator's seat.
WARNING
Disc blades have two sharp cutting edges that can cause serious injury. Exercise caution and wear gloves when working
with, or near, blades.
WARNING
Damaged or loose disc blades or blade attachment hardware can be ejected during machine operation and may cause
personal injury or machine damage.
For hardware replacement instructions, refer to
1. Shut down the engine, and remove the key from the ignition.
262634
MAINTENANCE AND SERVICING
Changing Eight
for
Figure 4.71: Counterclockwise Disc Rotation
Figure 4.72: Clockwise Disc Rotation
Removing Disc Blades, page 186
184
and
Installing Disc Blades, page
187.
Revision A

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the R1 Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

R113 ptR116 pt

Table of Contents