Driveline Guards; Removing Driveline Guards - MacDon R1 Series Operator's Manual

4.5.9 Driveline Guards

Guards protect the U-joints from dirt, dust, and debris.

Removing Driveline Guards

Removing the driveline guards that protect the U-joints from dirt, dust, and debris.
WARNING
Do NOT operate the machine without the driveline guards in place and securely fastened.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator's seat.
1. Shut down the engine, and remove the key from the ignition.
2. Remove driveline (A) from which the guard is going to be
removed. For instructions, refer to one of the following
procedures:
Removing Primary Driveline, page 245
Removing Hitch Driveline, page 248
Removing Clutch Driveline, page 255
3. Remove three self-tapping Phillips head screws (A) from
base cone (B).
262634
MAINTENANCE AND SERVICING
Figure 4.235: Driveline
Figure 4.236: Phillips Head Screws Installed in
Base Cone
268
A
A
B
Revision A