IMPORTANT:
Drain the gearbox lubricant when the lubricant is warm. If the lubricant is cold, idle the machine for approximately
10 minutes prior to draining.
1. Lower the rotary disc pull-type fully.
2. Shut down the engine, and remove the key from the ignition.
3. Remove four M10 hex flange head bolts (A) and vertical
driveshield (B).
4. Remove two M10 hex flange head bolts (A) and cover
plate (B).
262634
MAINTENANCE AND SERVICING
Figure 4.258: Vertical Driveshield
Figure 4.259: Cover Plate
281
B
A
B
A
Revision A
Need help?
Do you have a question about the R1 Series and is the answer not in the manual?