MacDon R1 Series Operator's Manual page 51

Table 2.2 Rotary Disc Pull-Type Specifications (continued)
Components
Drive
Conditioner system
Conditioner speed
Length of rolls
Roll diameter
Roll diameter
Intermeshing steel bars
Intermeshing polyurethane bars
Swath width
Forming shields
Conditioner – Finger Type
Drive
Conditioner system
Conditioner speed
Rotor length
Rotor diameter
Swath width
Forming shields
Ground Speed
Recommended cutting
Recommended transport
Tractor Requirements
Power Take-Off (PTO) power minimum
4
Hydraulics
Hydraulics 4
Hitch
NOTE:
Tractor must be equipped with a cab.
2. Can be set to 600 rpm by interchanging the pulleys.
3. Do NOT exceed maximum transport speed of 32 km/h (20 mph).
4. The transport system option uses the same hydraulic circuit as the hitch swing.
5. The single-acting header lift circuit is converted to double-acting when the transport system option is installed.
262634
PRODUCT OVERVIEW
Steel on steel
chevron
Polyurethane
intermeshing
3
Pressure
Controls
R113
4HB belt driven enclosed timing gearbox and driveline
Intermeshing rolls (steel or polyurethane)
900 rpm
3275 mm (10 ft. 9 in.)
229 mm (9 in.) / 179 mm (7 in.) O.D. tube
254 mm (10 in.) / 203 mm (8 in.) O.D. tube
229 mm (9 in.) / 179 mm (7 in.) O.D. tube
254 mm (10 in.) / 203 mm (8 in.) O.D. tube
915 2896 mm (36 114 in.)
Carrier mounted assembly with adjustable side deflectors
4HB belt driven
V-shaped tines on rotating drum
896
3275 mm (10 ft. 9 in.)
648 mm (25 1/2 in.) / 152 mm (6 in.) O.D. tube
915 2896 mm (36 114 in.)
Carrier mounted assembly with adjustable side deflectors
8 15 km/h (5 10 mph)
30 km/h (20 mph)
74 kW (100 hp)
13.71 MPa (2000 psi)
Two double-acting / one single-acting
Drawbar, two-point, or quick attach
33
R116
2
rpm
93 kW (125 hp)
5
Revision A