Replacing Red Brake/Tail Light Fixture - MacDon R1 Series Operator's Manual

Rotary disc pull-type
Hide thumbs Also See for R1 Series:
Table of Contents

Advertisement

3. Remove two Phillips screws (A) from the fixture. Remove
the plastic lens.
4. Replace the bulb.
NOTE:
Bulb Trade #1157.
5. Reinstall the plastic lens and screws.

Replacing Red Brake/Tail Light Fixture

Replace the red brake/tail light fixture if they are damaged.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator's seat.
DANGER
Ensure that all bystanders have cleared the area.
1. Lower the rotary disc pull-type fully.
2. Shut down the engine, and remove the key from the ignition.
3. Cut cable ties (A) securing the harness covering to the light.
4. Retrieve the connections from inside the harness covering
(approximately 150 mm [6 in.] from light) and disconnect
the wires (not shown). If necessary, remove the tape.
5. Remove four nuts (B) securing the light to the bracket.
Remove the light, and the pull wires through the hole in the
bracket.
6. Feed the connectors of the new light (not shown) through
the hole in the bracket, and position the light onto the
bracket.
7. Install four nuts (B) and tighten them.
8. Connect the wires to the connectors in the harness, and
secure the harness covering with tape and cable ties (A) as
required.
262634
MAINTENANCE AND SERVICING
Figure 4.282: Plastic Lens and Screws
Figure 4.283: Red Hazard Light and Mounting Bracket
294
A
B
A
Revision A

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the R1 Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

R113 ptR116 pt

Table of Contents