Lifting - INVT Goodrive880 Series Hardware Manual

Goodrive880 Series Inverter Unit Hardware Manual

3.3.4 Lifting

Inverter unit

Attach the required lifting ring to the locations shown in the figure, use the sling to slowly lift the unit end,
move the unit until it is completely lifted, place it vertically in the empty and flat place, and then unfold the
anti-tipping stand at the lower front of the unit. Figure 3-4 shows the anti-tipping stand location.
Lifting ring
Note: Use the lifting ring on the top of inverter unit for lifting and moving. Never apply force to the
positive or negative bus terminals.
The inverter unit has a high center of gravity and must be placed on a flat and solid ground with sufficient
support strength and a tilt angle of less than 5°. Failure to comply with this requirement will cause the
inverter unit to tip over or topple over, which may result in serious injury or property damage.
202311 (V1.0)
Sideboard 1
Sideboard 2
Figure 3-5 Unit top structure
Lifting ring
Figure 3-3 Unpacking
Figure 3-4 Unit lifting
Anti-tipping stand
Never apply force
Mechanical installation
Cover
Inverter unit
EPE
28