Advertisement
Mounting Instructions EVM-4, EVM-6, EVM-8, EVM-10
Remove the filament.
•
Pick up a new filament with the tweezers.
•
Place it on the bottom part of the clamping pieces.
•
Make sure that the spiral lies against the projections of the assembly tool.
•
The filament is now correctly adjusted and can be fixed with the filament clamps.
•
Version 1.3.19
Fig. 26 Clamping pieces and assembly tool
Fig. 27 Fastening and clamps
Fig. 28 Filament adjustment
page 57/64
Right and left clamping piece
Filament holder
placed in the
assembly tool
Screws and washers
Right and left
filament clamp
Ferrotec GmbH
Advertisement
