Table of Contents
Advertisement
2.11 Powering on the System
2.12 Configure the System
Figure 2-15 Instrument configuration menu
EAR99 Technology Technology Subject to Restrictions Contained on the Cover Page
The system's power switch is located on the lower right side
panel, near the front of the instrument.
1. Switch the rear panel circuit breaker to O
2. Press the switch to turn the system on. The system will
begin its startup routine, which includes self- diagnostics.
Note
The momentary power button on the right side of the instru-
ment can be used to boot up the system or shut it down on a
daily basis. The rear panel power switch is only used when you
desire to completely remove power from all internal electronics.
3. The system is ready for operation when the PeakTrak
screen is displayed.
Before operating the system, it should be configured to best meet
your needs. To configure the system, open the C
window by selecting T
OOLS
menu.
The configuration window has 3 tabs: I
, N
C
R A T I O N
E T W O R K
Network Configuration settings are discussed in Section 4.
Adjust the selections on the I
U
P
tabs for the desired operation and then click
SER
REFERENCES
O
to save the settings.
K
Note
Some configuration settings do not take effect until the system
is restarted. See Section 2.13.4.
CombiFlash NextGen Systems
Section 2 Preparation
> C
from the PeakTrak
ONFIGURATION
NSTRUMENT
, U
O N F I G U R A T I O N
S E R
C
NSTRUMENT
.
N
®
ONFIGURATION
C
-
ONFIGU
P
.
R E F E R E N C E S
or
ONFIGURATION
2-15
Advertisement
Table of Contents
