Table of Contents
Advertisement
CombiFlash NextGen Systems
Section 3 Operation
3.4 During the Separation
3.4.1 Run Control Buttons
Figure 3-1 M
S
AIN
EPARATION
3-6
• Select H
IGH
weak detection on the mass spectrometer.
• For situations in-between, select M
Detection Ions – Enter up to 4 ions, or a range and up to 3 ions.
The ions may be either positive or negative.
You may allow the system to proceed with the gradient while
monitoring the progress on the PeakTrak main window. If
desired, all method parameters may be modified during the sepa-
ration without stopping the separation. Changes to the gradient
may be made by dragging the solvent inflection points with your
finger without stopping the pump.
As the run progresses, the absorbance trace(s) is displayed while
the separation continues until the end of the run defined by the
run length setting.
During the run, data is automatically saved to the internal data
storage every few seconds. You can manually save a R
text (in XML format) or PDF to a flash drive while stopped or any
later time as long as the data file has not been deleted.
If a flash drive is in the USB port at the end of the separation,
the PDF file is automatically saved on this drive in addition to
the system's internal hard drive.
To automatically save a text or PDF file to a network location
after each run, configure the network file save configuration
options found under T
C
tab (Section 4.1.3).
ONFIGURATION
The following information will correspond with Figure 3-1.
screen
Start – The S
TART
ration, this becomes the I
EAR99 Technology Technology Subject to Restrictions Contained on the Cover Page
for lightly loaded columns or samples with
EDIUM
> C
OOLS
ONFIGURATION
button starts the separation. During the sepa-
H
button.
SOCRATIC
OLD
.
F
as
UN
ILE
> the N
ETWORK
Advertisement
Table of Contents
