Table of Contents
Advertisement
CombiFlash NextGen Systems
Section 2 Preparation
Figure 2-3 Location of the shipping clamps
2-4
Elevated flammable vapor levels are possible. Ensure that the
waste container is adequately ventilated, preferably by placing it
in a fume hood.
The CombiFlash NextGen instrument comes with the solvent
inlet lines and waste lines pre-assembled to it. To install the unit:
1. Remove the 2 screws and shipping clamps identified in
Figure 2-3. This releases the tubing lines for placement in
the solvent supply and waste reservoirs.
Note
For convenience, the inlet filter and inlet line tubing assemblies
have been pre-assembled with a bottle cap that is typical for the
region (GL 38 in the USA and GL 45 in the rest of the world). If
these caps aren't suitable for your containers, you will have to
make modifications as needed.
2. Place the solvent lines in the appropriate solvent supply
containers.
If the solvent lines are unable to reach the supply container (such
as when placed below the work surface), the third clamp that
retains the tubing above the inlet ports can be removed. In
addition, solvent supply extension lines are available and have
EAR99 Technology Technology Subject to Restrictions Contained on the Cover Page
CAUTION
Advertisement
Table of Contents
