Table of Contents
Advertisement
CombiFlash NextGen Systems
Section 2 Preparation
Figure 2-13 Loading test tubes
Figure 2-14 Inserting the collection tube rack
2-14
2. While holding the rack with the tube size label visible (Fig-
ure 2-14), insert the racks into the system. Slide the rack
in until it stops. You can feel it drop into its seated position
when it is properly loaded.
An incorrectly installed rack will cause the rack to be mis-
aligned under the fraction collector arm. Misaligned racks
might cause fractions to miss the tube opening or deposit in
the wrong tube. Always ensure the tube size label is visible (that
is, facing outward) and the rack is pushed in until it is seated.
When you turn the power switch to O
ically detect the type of rack and configure program settings
accordingly. Later, in Section 2.13.1, you can configure the
maximum volume for each tube size if you want smaller fractions
than the tube capacity.
EAR99 Technology Technology Subject to Restrictions Contained on the Cover Page
Tube Size Label
CAUTION
, the system will automat-
N
Advertisement
Table of Contents
