Table of Contents
Advertisement
CombiFlash NextGen Systems
Section 2 Preparation
Figure 2-1 Remove screw holding the arm in place
Figure 2-2 Location of screw storage
2-2
Compare the contents of the boxes with the enclosed packing
slips. If there are any shortages, contact Teledyne ISCO immedi-
ately.
The fraction collector arm is stowed to prevent damage during
shipping. Perform the following steps to release the arm after
shipment.
1. Loosen the screw retaining the arm to the right side of the
fraction collection area (Figure 2-1).
2. Pull off the front cover of the unit by gripping the edges of
the cover and pulling forward off the instrument.
3. Store the screw by screwing it into the screw storage.
(Figure 2-2).
4. Replace the front cover by pressing back onto the instru-
ment.
5. The screw should be reinstalled if the system must be
shipped again.
EAR99 Technology Technology Subject to Restrictions Contained on the Cover Page
Advertisement
Table of Contents
