Table of Contents
Advertisement
3.5.1 Main Separation
Screen
Figure 3-3 M
S
AIN
EPARATION
EAR99 Technology Technology Subject to Restrictions Contained on the Cover Page
The CombiFlash NextGen system comes configured as an open
access system with all work done in a single common area. If so
configured, the screen above is not shown at startup. In addition,
it can be configured for multiple, individual users who can be
assigned individual passwords. In this case, the screen in
Figure 3-2 is displayed after startup or individual logoff. In
either case, the S
be selected, followed by a login screen (if activated for the user).
Once logged in, the M
Figure 3-3).
The M
S
AIN
EPARATION
method until an RFID tagged column is sensed, or until the user
selects a column via the C
non-RFID tagged columns).
screen
• If the displayed method is acceptable, the S
will start the separation.
• If a S
AMPLE
current date and time. Also, there is no need to save the
method to perform a separation. The PeakTrak software
treats methods as a temporary method discarded after
each separation. If desired, you can save the method at
any time for future reuse. All method parameters are
stored with the data file and printed on the report, so no
information about the separation is lost.
• If the displayed method doesn't meet your needs, it can
be edited before use. For example, if the suggested
gradient isn't optimal, the gradient can be adjusted by
dragging the inflection points to the desired position. If
another gradient inflection points is desired, select the
I
P
NSERT
OINT
gradient to insert it. The M
CombiFlash NextGen Systems
U
drop down allows the username to
ELECT
SER
S
screen is shown (Figure
AIN
EPARATION
screen (Figure 3-3) defaults to a 4 g silica
drop down list (for support of
OLUMN
N
is not entered, it defaults to the
AME
button, then touch a location on the
ETHOD
Section 3 Operation
button
TART
E
button at the
DITOR
3-9
Advertisement
Table of Contents
