Mechanical Specifications - HPE ProLiant MicroServer Gen10 Plus v2 User Manual

Specifications Specifications
Temperature range* Temperature range*
Operating
Nonoperating
Relative humidity (noncondensing) Relative humidity (noncondensing)
Operating
Nonoperating
Altitude Altitude
Operating
Nonoperating
Standard operating support Standard operating support
10°C to 35°C (50°F to 95°F) at sea level with an altitude derating of 1.0°C per every 305 m (1.8°F per every 1000 ft) above sea level to a
maximum of 3050 m (10,000 ft), no direct sustained sunlight. Maximum rate of change is 20°C/hr (36°F/hr). The upper limit and rate of
change may be limited by the type and number of options installed.
System performance during standard operating support may be reduced if operating above 30°C (86°F).
Extended ambient operating support Extended ambient operating support
For approved hardware configurations, the supported system inlet range is extended to be:
5°C to 10°C (41°F to 50°F) and 35°C to 40°C (95°F to 104°F) at sea level with an altitude derating of 1.0°C per every 175 m (1.8°F per
every 574 ft) above 900 m (2953 ft) to a maximum of 3050 m (10,000 ft).
40°C to 45°C (104°F to 113°F) at sea level with an altitude derating of 1.0°C per every 125 m (1.8°F per every 410 ft) above 900 m
(2953 ft) to a maximum of 3050 m (10,000 ft).
The approved hardware configurations for this system are listed on the Extended Ambient Temperature Guidelines for Gen10 Plus HPE
ProLiant and HPE Apollo servers and HPE Synergy:
https://www.hpe.com/support/ASHRAEGen10_Plus https://www.hpe.com/support/ASHRAEGen10_Plus
System performance might be reduced if operating in the extended ambient operating range.

Mechanical specifications

Mechanical specifications
Dimension Dimension
Height
Depth
Width
Weight, minimum (one drive and one DIMM
installed, no iLO enablement module or expansion
card installed)
Weight, maximum (four drives, two DIMMs, iLO
enablement module, and an expansion card
installed)
Value Value
—
10°C to 35°C (50°F to 95°F)
-30°C to 60°C (-22°F to 140°F)
—
8% to 90%
28°C (82.4°F) maximum wet bulb temperature
5 to 95%
38.7°C (101.7°F) maximum wet bulb temperature
—
3050 m (10,000 ft). This value may be limited by the type and number of options installed.
Maximum allowable altitude change rate is 457 m/min (1500 ft/min).
9144 m (30,000 ft). Maximum allowable altitude change rate is 457 m/min (1500 ft/min).
Value Value
11.89 cm (4.68 in)
24.50 cm (9.65 in)
24.50 cm (9.65 in)
4.82 kg (10.63 lb)
7.20 kg (15.87 lb)
HPE ProLiant MicroServer Gen10 Plus v2 User Guide 77