Parameters - Schenck process Disomat Opus Operating Manual

Function Variants

6.5.6 Parameters

Table of parameters for the 'Cargo Scale Function Variant'
Parameter Name Default Required
Block 'Output 3'
FastComp.High
FastComp.Low
Block 'Output 4'
FastComp.High
FastComp.Low
Block 'Weighing'
Timeout 0.0
Printing option OFF
Block 'Print Total'
Timeout 0.0
Printing option OFF
Block 'Analog Source'
Source Gross
MIN reference value 0
MAX reference value 0
Block 'PLS-AOut'
Reference value 20
Block 'Analog Output'
Analog output OFF
BV-H2313 GB 0630
- 118 -
Recommended
Setting Setting
HIGH > LOW
LOW > HIGH
LOW > HIGH
HIGH > LOW
0.0
= MAX reference
value
4 ... 20 mA
Comments
Min. contact
Max. contact
Max. contact
Min. contact
0 sec: Print-out without no-motion state
monitoring
1 -999 sec: Waiting-time to no-motion state.
'OFF': No data output to the data
processing system and no
balancing
'to data Data output to the data
processing processing system after
system': printout
'Balance': Balance before printout
'data processing Balance before printout
system/balance': and output data to the data
processing system after
printout
see above
This block selects what quantity is issued at the
analog output and how it is scaled.
Some quantities and reference values are:
Source Dimension for Min/Max
Gross: The scale's dimension
Net: The scale's dimension
dW/dt: The scale's dimension / h
Fieldbus: none; the IEEE value of
the PLS-AIn is issued
Controller magnitude: Not available in Opus;
output is set to 0
Setpoint: The scale's dimension
Actual value %: Percent of setpoint
Actual value of dim: The scale's dimension
Residual value %: Percent of setpoint
Residual value of dim: The scale's dimension
Nex t setpoint The scale's dimension
Scaling parallel output of the analog output to PLS
analog output 1.
®
DISOMAT Opus – Operating Manual
© Schenck Process GmbH, Darmstadt
Cargo Scale