Schenck process Disomat Opus Operating Manual page 112

Function Variants
Parameter Name Default Required
Setting
Main contact 0.0
Tolerance 0.0
Optimization factor 0.0
Parameters of the function
commiss ioning) or vi DIS a OPLAN
Block 'Discharge W eigh ing '
MaxFillWeight 0.0 Si
fe
Ma
> S
FillWeight 0.0
Optimization No
No-Motion Time 20.0
Timeout 0.0
Settling time: 0.0
Block 'Single Printout'
Timeout 0.0
Printing option OFF
Block 'Print Total'
Timeout 0.0
Printing option OFF
Block 'Print Balance'
Timeout 0.0
Printing option OFF
Block 'Analog Source'
BV-H2313 GB 0630
- 106 -
Recommended
Setting
Tolerance
< Pre-contact
0. 2
variant; can be set via '421:Parameter' (with parameter password when
ngle
eding:
xFillWeight
etpoint
Comments
with reference to setpoint, e.g. 5 kg; switchi ng threshold
= 95 kg
Valid if function block parameter 'Optimiz ion=Yes'
The maximum weight in the weigh
Start/stop optimization (Yes/No)
The maximum time it waits for no-motion state af
fe eding.
0 sec: Tare memory is not cleared after
feeding
> 0 sec: Tare memory cleared after input
time. Restart only possible after
this time.
Ti me that can be set between the main contact
dr opping (dri bbl e feed) and tolerance check
0 sec: Print-out without no-motion s
monitoring
1-999 sec: Waiting-time to no-motion state.
'OFF': No data output to the data
processing system and n
balancing
'to data Data output to the data
processing processing system after printout
system' :
'Balance': Balance before printout
'data Balance before printout and
processing output data to the data
system/bal processing system after printout
ance':
see above
see above
®
DISOMAT Opus – Operating Manual
© Schenck Process GmbH, Darmstadt
Discharge Scale
at
ing bin
ter
tate
o