Operating Activities; Parameters - Schenck process Disomat Opus Operating Manual

Function Variants

6.2.5 Operating Activities

There are three types of printout and one print repeat function. For information on
formatting, see manual BV-H2313, Item 5.2.1.
Single Printout
After every fill operation, aborted or completed, system automatically performs a
single printout (weighing report). For single printout, DISOMAT uses form format 2.
Totals Printout
After one (or multiple) weighing operations, you can print total by pressing
[SHIFT]+[F3] (function key F6). System outputs the cumulative weight value of all fill
operations. Then, totals value (balance) is cleared, i.e. the totals weight of all weighing
operations performed and the number of fill operations are set to zero. For totals
printout, DISOMAT uses form format 3.
Sub-Totals Printout
[SHIFT]+[F1] (function key F4) lets you print current balance total at any time. After
one (or multiple) weighing operations, you can print sub-total using menu item
'33:Print3'. Print pattern is the same as with totals printout, however, the totals
memory is not cleared.

6.2.6 Parameters

Table of parameters for the 'Filling Scale Function Variant'
Parameter Name Default Required
Setting
Input of current sort and setpoint via menu item '1:Enter Setpoint'
Setpoint 0 Single feeding:
Setpoint >
MaxFillWeight
As many as 2 definable material data in '473:Material Data' ; Key in with parameter password
Prefill value 0.0
Pre-contact 0.0
Main contact 0.0
Tolerance 0.0
Optimization factor 0.0
Parameters of the function variant; can be set via '421:Parameter' (with parameter password at
commissioning) or via DISOPLAN
Block 'Fill Weighing'
MaxFillWeight 0.0 Single feeding:
MaxFillWeight <
Setpoint
Multiple feeding:
MaxFillWeight < Sum;
Total of all setpoints of
multiple feeding
Discharge Weight 0.0
Optimization No
No-Motion Time 20.0
®
DISOMAT Opus – Operating Manual
© Schenck Process GmbH, Darmstadt
Recommended Comments
Setting
Can be set after pressing the F3 'MatSet'
key and selecting the material
Absolute value for change-over from dribble
feed (after start) to full feed (spillage
protection)
Pre-contact with reference to the main contact; for
> Tolerance instance, SW = 100 kg;
Switching threshold = 100 - VK - HK
with reference to setpoint, e.g. 5 kg;
switching threshold = 95 kg
Tolerance
< Pre-contact
0.2 Valid if function block parameter
'Optimization=Yes'
The bin is discharged after feed operation if
this threshold is passed.
It has to be below this weight when
discharging.
Please be aware of material build-up
Start/stop optimization (Yes/No)
The maximum time it waits for no-motion
state after feeding.
Filling Scale
= 100 - 10 - 5
= 85 kg
0630 BV-H2313 GB
- 99 -