Operating Activities; Parameters - Schenck process Disomat Opus Operating Manual

Function Variants
Action
5. If required, abort
discharging.
6. Terminate discharging.
7. Discharge hopper.

6.3.5 Operating Activities

There are three types of printout and one print repeat function. For information o
formatting, see manual BV-H2313, Item 5.2.1.
Single Printout
After every fill operation, aborted or completed, system automatically perform
single printout (weighing report). For single printout, DISOMAT uses form format 2.
Totals Printout
After one (or multiple) weighing operations, you can print total by pressing
[SHIFT]+[F3] (function key F6). System o
operations. Then, tota
operations performed and the number of fill operations are set to zero. For total
printout, DISOMAT uses form format 3.
Sub-Totals Printout
[SHIFT]+[F1] (function k
o ne (or multiple) weighing operations, you can print sub-total using menu item
'33:Print3'. Print pattern
memory is not cleared.
6.3.6 Parameter s
Table of parameters for the 'Dis harge Scale Function Variant'
Parameter Name Default Required
Setting
Input of current sort and s etpoint via menu it
Setpoint 0 Single
feeding:
Setpoint <
Ma
As many as 2 definable material data in '
Prefill value 0.0
Pre-contact 0.0
®
DISOMAT Opus – Operating Manual
© Schenck Process GmbH, Darmstadt
Display (e.g.)
W4104:Filling
Aborte d
Net T 59.0 kg Filled weight and discharging
utputs the cumulative weight value of all fill
ls value (balance) is cleared, i.e. the totals weight of all weighing
ey F4) lets you print current balance total at any time. After
is the same as with totals printout, however, the totals
c
Recommended
Setting
em '1:Enter Setpoint'
xFillWeight
473:Material D
Pre-contact
> Tolerance
Key(s); Comments
+ 'Abort' key
operation are balanced and printed.
Weighing is complete.
Filled weight is displayed for a set
timeout; then, GROSS is displayed.
Next discharging operation can start
after timeout.
Upon disch arge weighing, hopper is
refilled as soon as fill level in
storage hopper falls below the Refill
value.
Comments
Can be set after pressing the F3 'MatSet'
selecting material
ata' ; Key in w ith the pa rame
Absolute value for change-over from dr
sta rt) to full feed (spil lage protection)
with ref erence to the main con
100 kg;
Switching threshold = 100 - VK - HK
= 100 - 10 - 5
= 85 kg
0630
Discharge Scale
n
s a
key and
ter passwo rd
ibble feed (after
tact; for instance, SW =
BV-H2313 GB
- 105 -