Removal And Installation Of Cover And Inlet Plate - Veikong VFD500 Series User Manual

VFD500 high performance vector control frequency inverter user manual
Remarks:
(1) B2 and H2 are the installation dimensions when the reactor base is included.
(2) Φd is the diameter of the installation screw hole of the whole machine.

3.1.3 Removal and installation of cover and inlet plate

 SIZEA～SIZE C( 0.75KW-15KW) Removal and installation of cover and inlet plate：
Step 1: Open the top cover
① Unscrew the screw on the cover
② Lift up the cover
③ Remove the cover from the front
① Step 1: Install the inlet board
② Put the inlet board from the top down into the
mounting position to ensure that the card buckles
Removal steps
Step 2: Take out the inlet board
① Hold down the sides of the inlet plate with your
thumb and middle finger
② Press to disengage the buckle and pull it out of the
board
Installation steps
Step 2: Install the upper cover
① Slant the front cover diagonally from the front to
the docking station
② Lower the cover plate toward the inlet board
③ Tighten the screws on the cover
- 18-
Chapter3 Product appearance and wiring